RDS Dock Hardware

Cast aluminum dock, deck and bridge hardware

2" Pipe Leg Dock Hardware

Set Descending Direction

1-10 of 18

Page:
  1. 1
  2. 2
  1. 2" Pipe Side Bracket (PLD002)
    $27.95

    The Pipe Side Brackets are used with 2" ID (app. 2.5" OD) pipe legs.

    Learn More
  2. 2" Pipe Corner Bracket (PLD004)
    $27.95

    The Pipe Corner Brackets are used with 2" ID (app. 2.5" OD) pipe legs.

    Learn More
  3. 2" Pipe Base (10" Diameter) (PLD006)
    $32.00

    The Pipe Base slides over 2" ID (app. 2.5 " OD) pipe. It should be used where the Lake or River bottom is soft or muddy. The base will prevent the pipe from sinking too far into the lake or river bottom and will eliminate a lot of the side to side motion (sway) in the dock.

    Learn More
  4. 2" Pipe Trim Cap (PLD008)
    $6.50

    The Pipe Trim Cap is used for protection from sharp edges on the 2" ID (app. 2.5" OD) pipe as well as adding a more professional look to your dock.

    Learn More
  5. 2" Pipe Dock Hardware Kit
    $141.75

    This 2" ID (app. 2.5" OD) Pipe Dock Hardware Kit includes 2 sets of trim caps, bases, side brackets and mounting hardware. For every section of dock you are building, just add another kit! Two kits pictured.

    Learn More
  6. 2" Clamp on Brace Bracket (PLD013)
    $18.95

    The 2" clamp on Brace Bracket should be used on installations where there is deep water, or if a boat is often moored at the dock, to reduce or eliminate side motion (sway). The bracket accommodates 2" ID (app. 2.5" OD) pipe.

    Learn More
  7. 2" Brace Bracket (PLD015)
    $13.95

    The Brace Bracket should be used on installations where there is deep water, or if a boat is often moored at the dock, to eliminate side motion (sway). Bracket slides onto 2" ID (app. 2.5" OD) pipe.

    Learn More
  8. Brace Clamp (PLWLD016)
    $13.95

    For an extra rigid dock, use four Clamp-on Brace Brackets in a cross pattern and our Brace Clamp attached to the center of the cross.

    Learn More
  9. Combination 1 1/2" or 2" Drive Cap (PLD009)
    $27.15

    The Combination Drive Cap is made from ductile iron and is used when driving the 1.5" ID (app. 2" OD) or 2" ID (app. 2.5" OD) pipe legs into the lake or river bottom to help prevent flaring damage to the pipe.

    Learn More
  10. 2" Pipe Point (PLD011)
    $30.00

    The 2" Pipe Point is used with 2" ID (app. 2.5" OD) pipe.  It can be used in any situation, but is very helpful where the Lake or River bottom is extra firm or rocky.

    Learn More

Set Descending Direction

1-10 of 18

Page:
  1. 1
  2. 2